1998 Dodge Ram Seat Belts Lock Up Every Now and Again

How To Install Seat Belts

by Cassandra Tribe

bobshotrod.com

Using seat belts tin can relieve your life and can salvage you and your community money. The safety factor is obvious, simply not everyone is aware that taxpayers behave 85 percentage of the cost (medical intendance, emergency response) when an accident involves a commuter who is not wearing a seat belt. Brand sure your seat belts are in working lodge; if they're worn out by age or from existence activated in an accident, y'all tin install some other gear up yourself.

Step 1

Trace the straps from the original seat chugalug back to the anchors that adhere the belt to the frame of the car. If you are installing seat belts that take a shoulder harness, the shoulder strap from the original belt will cease in an anchor on the side of the car frame. Lap belts volition have an anchor in the bottom of the frame.

Step 2

Lock the crescent wrench on the side of the anchor commodities that is in the automobile. Either have a helper concur the wrench stationary, or make sure that if the wrench turns, the handle will become blocked against the actual car seat and not be able to go along turning equally you piece of work the other end of the bolt free.

Step iii

Locate the bottom of the anchor commodities. For lap belts, you volition notice it protruding through the bottom of the car. For shoulder belts, you will not be able to admission the end of the bolt but can immediately begin to turn the crescent wrench in a counterclockwise direction to unscrew the bolt from the side frame. For lap belts, attach a socket wrench to the nut on the commodities nether the car and turn the socket counterclockwise until it is completely off the anchor commodities. Withdraw the bolts from the commodities holes.

Step 4

Remove the erstwhile seat belts and anchoring hardware. If yous have a retractable seat belt, remove the entire case that contains the spool that held the old belt. Install the new belt past bolting the new spool case in the same position as the old one or, if it is a "direct belt" that does not retract, commodities the anchor plate downwards. The anchor plate will be ane of the ii plates included with your replacement belt only the simply i with a 45-degree angle to it. Your retractable chugalug is completely installed at this point. To finish installing a straight chugalug, at that place'due south one more step.

Thread the belt through the anchor plate and effectually the locking plate. The locking plate is the plate that looks like to a large, apartment washer. Laissez passer the belt through the hole in the heart once and then loop it over the meridian of the locking plate and dorsum through the center once more and so both plates lock together and the belt does not motion when you pull on the belt. Repeat steps four and 5 to install the other side of the seat chugalug.

Tips

• Install the side of the belt that goes between the seats first as it tends to be the more than difficult and aggravating one to do. Doing this part while y'all are fresh will make the process faster than trying to struggle with information technology afterward yous have already been working for a while.

Things You'll Demand

• Socket set up
• Crescent wrench
• Replacement seat belt

Warnings

• Supercede your seat belts after whatsoever blow or incident in which the seat chugalug was engaged (where the seat belt "locks" to prevent you lot from moving). This way yous are sure that your belts are in their all-time working condition.

Writer Bio

Cassandra Tribe has worked in the structure field for over 17 years and has experience in a variety of mechanical, scientific, automotive and mathematical forms. She has been writing and editing for over 10 years. Her areas of involvement include culture and society, automotive, computers, business, the Internet, science and structural engineering and implementation.

More Articles

kennedywitocces.blogspot.com

Source: https://itstillruns.com/install-seat-belts-5154909.html